Control Panel Operation - Jacuzzi Platinum Series Owner's Manual

Control Panel Operation

Initial Start-Up
The spa will automatically begin to operate when elec-
trical power is applied. There is no ON/OFF switch for
the spa system.
The control system is designed so that by simply con-
necting the spa to its properly grounded power source
and pressing the mode button, the spa will function
properly and safely at 100°F. In this mode, all control
panel buttons are completely functional. To use the full
capabilities, it is important to set the time of day.
Setting the Time of Day:
Press then
then or
After either button is pressed once, hours will advance
or decrease automatically in one-minute increments.
Press either or
display' s time-setting cycle.
Filter Cycles
The spa is filtered for 2 hours, twice a day. The display
will show FILTER during filtration.
activate for 30 seconds at the start of each filter cycle to
clean out the air channel. The ozone generator also
operates during the filter cycles.
Note: The ozone generator will be disabled for 1
hour whenever the pump, blower, or light button is
pressed.
Changing Filter Cycles
If the preset times are inconvenient, if a different dura-
tion is preferred, or if you wish to leave the heater OFF
during filtering, the following procedure can be used to
change the automatic filter cycle settings.
Press . Time of day will be shown. Then press
. SET TIME message will be shown. Then
www.clearcreekspas.com
OPERATION
.
again to stop the
The blower will
press . SET START FILTER 1 message
will be shown. At this point, each time the program
button is pressed, the filter start time, the heater
enable status, and the filter stop time will be indicated
on the display. When the filter start or filter stop times
are displayed,
press or
When the SET HEAT message is displayed, press
or to set the center display to ON or
OFF. In the ON position, the spa will warm to the set
temperature during the filter cycles. In the OFF position,
the heater, in the economy mode, will not be activated
during the filter cycles.
After the filter set routine, press
through all the start and stop times for both filter cycles.
Follow the same procedure to adjust the FILTER 2
settings. To exit the filter set routine press
and the display will show the current water temperature.
Note: To properly clean and maintain your spa,
filtering time of at least two hours per day (total of
both cycles) is recommended.
Panel Lock
The panel lock is provided to prevent tampering with the
control panel. When the panel lock is engaged, all
the automatic spa functions will operate normally.
Press these buttons within 3 seconds to activate the
lock. When locked, the display will show the spa
temperature along with the lock symbol. All the panel
buttons are now deactivated except the program button,
which is used to initiate the unlock sequence.
Press . The center display will read
.
Then The center display will read
to reset the times.
to proceed
.
7