Table of Contents
Advertisement
First time setup
MFP panel:
Restart
MFP panel:
Printer
Printer panel:
operator panel
6
Wait for the MFP to initialize. When the scanner comes on,
there is a short wait cycle while the firmware is initialized.
Please Set Date/Time is displayed on the first line of the
MFP control panel and "Please Wait..." is displayed on the
second line.
Do not turn off the printer or unplug the scanner until the
Please Wait... message disappears from the control panel.
Please Set Date/Time
Please Wait...
Please Wait...
24MB of memory required
for Fax...
Hardware setup is now complete. You are ready to configure the MFP.
Turn on the scanner and printer
When initialization is completed, the
message disappears. The
Wait...
Set Date/Time
need to set required fax information.
When you restart the MFP, a
message appears on the second line of the
control panel. When initialization is completed,
the MFP control panel displays the current time
and date, plus the
When you turn on your printer after installing the
MFP, you may see the message on the left. The
Analog Fax option is disabled unless there is a
minimum 24MB of printer memory.
If you receive this message, install additional
printer memory to meet or exceed the 24MB
requirement.
29
Please
Please
prompt indicates that you
Please Wait...
Ready
message.
Advertisement
Table of Contents
