Verifying The Ip Settings - IBM Infoprint M22 MFP Setup Manual

Verifying the IP settings

Note:
On Windows
computers, click Start
Programs Command
prompt (or Accessories
Command prompt if using
Windows 2000).
Attaching the
scanner shelf
3
Press until you see Std Net Setup (or Network 1 Setup or
Menu
Network 2 Setup), and then press
4
Press until you see TCP/IP, and then press
Menu
5
Press until you see Set IP Address, and then press
Menu
.
Select
6
Change the address by pressing
each number. Press
when you are finished.
Select
The message Saved appears briefly.
7
Press until you see Set IP Netmask, and then press
Menu
.
Select
8
Repeat step 6 to set the IP Netmask.
9
Press until you see Set IP Gateway, and then press
Menu
.
Select
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press
Ready state.
1
Print another network setup page. Look under the "TCP/IP"
heading and make sure the IP address, netmask, and gateway
are what you expected.
See "Printing a network setup page" on page 20 if you need
help.
2
Ping the printer and verify that it responds. For example, at a
command prompt on a network computer type ping followed
by the new printer IP address (for example, 192.168.0.11):
ping xxx.xxx.x.xx
If the printer is active on the network, you receive a reply.
1
Turn the printer off.
2
Unplug the 16 AWG power cord or printer power cord from the
grounded outlet.
Set up the printer
21
.
Select
to increase or decrease
Menu
to move to the next segment. Press
Select
to return the printer to the
Go
.
Select