To Remove Wheels For Repair - Husqvarna CZE 4818 Operator's Manual

TO ADJUST CONTROL LEVERS
(See Fig. 19)
Sitting on the seat, in the operators position,
press both control levers forward. If both control
levers line up with each other, then no
adjustment is needed. If they do not line up,
follow instructions below.
• Identify which control lever moves further
forward.
• Using a 9/16" wrench, slightly loosen the
bottom hex bolt (about 1/2 turn) on the
opposite control lever.
• Move both control levers to the front again
and apply more pressure to the control lever
that you loosened to bring the two control
levers in line with each other.
• Tighten hex bolts.

TO REMOVE WHEELS FOR REPAIR

FRONT CASTER TIRES
• Park mower on a level surface and apply
park brake.
• Jack up the front end of the mower.
• Using a 3/4" wrench and/or socket w/ drive
ratchet, remove hex nut and hex bolt from
the caster fork.
• Remove the tire from the fork.
• Remove the spacer from the inside of the
caster rim.
• Repair tire
• Reassemble in the reverse order of the
previous steps.
REAR TIRES
IMPORTANT:
Block front tires to prevent the
mower from rolling.
• Park mower on a level surface and apply
park brake.
• Jack up the rear end of the mower on the
side of the damaged tire.
• Remove 4 lug nuts to allow wheel removal.
• Repair tire.
• Reassemble in reverse order of previous
steps.
NOTE:
To seal tire punctures and prevent flat
tires due to slow leaks, tire sealant may be
purchased from your local parts dealer. Tire
sealer also prevents tire dry rot and corrosion.
SERVICE AND ADJUSTMENT
2
FIGURE 19
1. CONTROL LEVER
2. CONTROL ARM
3. HEX BOLTS
4. NEUTRAL SLOT
33
1
3
4
CZ-2