See Figure - Husqvarna CZE 4818 Operator's Manual

TO ADJUST ANTI-SCALP ROLLERS

(See Figure 6)

FIGURE 6
1. ANTI-SCALP ROLLER
Anti-scalp rollers are properly adjusted when
they are just slightly off of the ground when the
deck is at the desired cutting height in the
operating position. Anti-scalp rollers then keep
the deck in the proper position to help prevent
scalping in most terrain conditions.
NOTE:
Adjust Anti-scalp rollers with the mower
on a flat level surface.
• Adjust the deck to the desired cutting height
(see "TO ADJUST DECK CUTTING
HEIGHT" in the operation section of this
manual).
• Using a 3/4" wrench and a 9/16" wrench,
remove the nut and shoulder bolt from the
anti-scalp roller.
• Lower the anti-scalp roller to the ground, and
raise it up to the next highest hole.
• Replace and tighten the nut and shoulder
bolt.
• Be sure to adjust all of the anti-scalp rollers
to the same position.
• Be sure to readjust the anti-scalp rollers if
the cutting height is changed.
IMPORTANT:
THE ANTI-SCALP ROLLERS
MUST NOT BE USED FOR GAUGE WHEELS
OR THE ROLLER AND DECK MAY BE
DAMAGED.
OPERATION
TO OPERATE MOWER
1
Your mower is equipped with an operator
presence system. When the engine is running,
any attempt by the operator to leave the seat
without first setting the park brake will shut off
the engine.
•
•
•
CZ-9
Do not operate the deck without either the
entire grass catcher, mulch kit or dis-
charge chute installed.
TO OPERATE ON HILLS
Do not drive up or down hills with slopes
greater than 10 degrees. And do not drive
across any slopes.
• The slowest speed possible should be used
before starting up or down hills.
• Avoid stopping or changing speed on hills.
• If stopping is absolutely necessary, pull drive
levers into the neutral position and push to
the outside of the unit and engage the park
brake.
IMPORTANT:
when released. This may cause a sudden stop
of the mower.
• To restart movement, release the park brake.
• Pull the control levers back to the center of
the mower and press forward to regain
forward motion.
• Make all turns slowly.
19
Select desired height of cut.
Start deck blades by pulling the PTO
switch up into the engaged position.
To stop the deck blades, press down on
the PTO Switch into the disengaged
position.
WARNING
WARNING
Control levers return to neutral