Table of Contents
Advertisement
TO TRANSPORT (See Fig. 7)
When pushing or pulling the mower, be sure to
engage the IZT (Integraded Zeroturn Transaxle)
bypass linkages. The IZT bypass linkages are
located on the rear of the frame, below the rear
engine guard.
CAUTION
Do not tow this vehicle, it may cause
damage to the drive system.
• Raise the deck into the highest cutting
position.
• Pull the IZT bypass linkages out and into the
slots and release so that it is held in the
bypass position.
• To reengage the IZT's to drive, reverse the
above procedure.
WARNING
Do not tow any trailers, etc. with this
mower. They may jackknife or overturn
causing damage to the mower and possi-
bly serious injury to the operator.
OPERATION
20
1
FIGURE 7
1. IZT BYPASS LINKAGE
FIGURE 7A
1. HEAD INSIDE OF REAR DECK
2. IZT BYPASS LINKAGE IN DRIVE POSITION
FIGURE 7B
1. HEAD OUTSIDE OF REAR DECK
2. IZT BYPASS LINKAGE IN BYPASS POSITION
CZ-10
1
2
CZ-11
1
2
CZ-12
Hide quick links:
Advertisement
Table of Contents
