The Computer Does Not Recognize This Product - Sony DSC-RX100M3 User Giude

[276] Troubleshooting
[Smart Remote Embedded] or [Send to Smartphone] is
canceled halfway.
When the remaining battery level is low, [Smart Remote Embedded] or [Send to Smartphone] may be
canceled halfway. Charge the battery pack and try again.
[277] Troubleshooting
The shooting screen for [Smart Remote Embedded] is
not displayed smoothly./The connection between this
product and the smartphone is disconnected.
Data communication between this product and the smartphone may fail due to signal conditions.
Place this product closer to the smartphone.
[278] Troubleshooting
You cannot use One-Touch connection (NFC).
Place the (N mark) on the smartphone and the
possible. If there is no response, move the smartphone a few millimeters or move the smartphone
away from this product, wait more than 10 seconds, and then touch them together again.
[Airplane Mode] is set to [On]. Set [Airplane Mode] to [Off].
Check whether the NFC function is activated on your smartphone. For details, refer to the instruction
manual of the smartphone.
Do not place any metal objects other than a smartphone near the
Do not contact two or more smartphones to this product at the same time.
If another NFC-based application is running on your smartphone, terminate that application.
[279] Troubleshooting

The computer does not recognize this product.

Set [USB Connection] to [Mass Storage].
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Wi-Fi
Wi-Fi
Wi-Fi
(N mark) on the product as close together as
(N mark).
Computers