Table of Contents
Advertisement
8.
Grip the Air Impact Wrench tightly with both hands, and squeeze the trigger
(20). The tool will operate and tighten the fastener.
9.
When the fastener is tightened, release the Trigger (20), and remove the tool
from the fastener.
10. If possible, check the actual torque applied to the fastener with a mechanical
torque wrench (not supplied).
11. If removing a fastener, rotate the Reverse Knob (45) counterclockwise,
assuming that the fastener is a standard right-hand thread. Always check to
be sure of the thread direction of any fastener before attempting to install or
remove it. If the fastener is a left-hand thread, turn the Reverse Knob (45) to
the right for removal.
12. Place an appropriate Impact Socket (not included) over the fastener. Holding
the Air Impact Wrench with both hands, squeeze the trigger (20). The
fastener should come off.
WARNING: If the fastener will not come off, first check to be sure of the direc-
tion of the thread. If you have the thread direction correct and the fastener will
not come off, DO NOT INCREASE THE AIR PRESSURE to the tool beyond 90
PSI. This may damage the tool. You may have to use penetrating oil, heat, or
a mechanical wrench to remove the fastener.
13. When you are done using this tool, turn off the air compressor, and
disconnect the air hose. Put the Air Impact Wrench away in its proper
storage place.
1.
Your Air Impact Wrench should be kept clean, dry and lightly oiled. When not
in use, store your tool in its original box in a suitable place where it will not
be exposed to water, corrosive materials, or undue banging around.
2.
Make sure this tool is disconnected from its power source before attempting
any maintenance.
3.
If your tool loses power, or you notice air leaks, take it to a certified
technician for service.
SKU 95098
In the reverse
position
45
Maintenance
Page 6
In the forward
position
REV 12/06
Advertisement
Table of Contents
