Central Pneumatic 95098 Assembly And Operating Instructions Manual page 4

18. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
19. Use proper size and type air pressure line and fittings. The
recommended air line for this tool is 1/2" delivering no more than 90 PSI.
Recommended air inlet size is 1/4" - 18 NPT.
20. Maintenance. For your safety, service and maintenance should be
performed regularly by a qualified technician.
21. You should maintain a proper regulator and moisture trap in your air
line at all times.
22. Compressed air only. Only use clean, dry and regulated compressed air at
no more than 90 PSI to power this tool. Never use oxygen, carbon dioxide or
any other bottled gas as a power source for this tool.
Note: Performance of this tool may vary depending on variations in local air
pressure.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
When unpacking, check to make sure the following parts are included.
(1) 1/2" Twin Hammer Composite Air Impact Wrench
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
If you are not using an in-line oiler, you should inject a few drops of pneumatic
oil into the air inlet of the tool after every hour of continuous use. Hold the
tool so the inlet is facing up, squeeze the trigger and place 1 or 2 drops of oil
in the inlet. Squeezing the trigger allows the oil to circulate in the mechanism.
Air Impact
Wrench
SKU 95098
Unpacking
Page 4 REV 12/06