Fujitsu ESPRIMO E4xx Operating Manual page 49

Installing an accessible 2
► Remove the cover (see chapter
► Remove the front panel (see chapter
► Remove the drive cover if one is fitted. To do this, press the corresponding drive cover
lightly out forwards and pull the drive cover forward out of the front panel.
► Remove the drive cage (see chapter
► Turn the drive cage over.
► Slide the drive into the casing (1). Make sure that the screw holes of the drive cage and
of the drive are aligned. The screw positions are identified with "HDD 2.5"".
► Fasten the drive into place with the screws (2).
► Install the drive cage (see chapter
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Secure the front panel on the casing (see chapter
► Install the cover on the casing again (see chapter
It may be necessary to modify the entry for the drive in the BIOS Setup.
Fujitsu
/ inch drive or an inaccessible 2
1
2
"Removing a cover", Page
"Removing the front panel", Page
"Removing the drive carrier", Page
2
"Installing the drive cage", Page
33).
2
2
1
38).
"Securing the front panel", Page
"Reattaching the cover", Page
System expansions
/ inch drive
1
2
34).
37).
35).
36).
45