Problem Solutions And Tips; Help If Problems Occur; Troubleshooting; Power Indicator Remains Off After You Have Switched On Your Device - Fujitsu ESPRIMO E4xx Operating Manual

Problem solutions and tips

Comply with the safety information in the "Safety" manual and the chapter
"Getting started", Page
If a fault occurs, try to rectify it in accordance with the measures described in the following documents:
• in this chapter
• in the documentation relating to the peripheral devices
• in the Help sections for the individual programs
• in the documentation for the operating system in use.

Help if problems occur

Should you encounter a problem with your computer that you cannot resolve yourself:
► Note the ID number of your device. The ID number is found on the type rating
plate on the back, the underside or the top of the casing.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "http://support.ts.fujitsu.com/contact/servicedesk"). When
you do this, please have ready the identity number and serial number of your system.

Troubleshooting

Power indicator remains off after you have switched
on your device
Cause
The mains voltage supply is faulty.
Internal power supply overloaded.
Fujitsu
13, when attaching or detaching cables.
Remedy
► Check that the power cable is correctly
plugged into the device and into a grounded
mains outlet.
► Check that the main switch at the rear of the
monitor is set to the "I" position.
► Switch the device on.
► Pull the power plug of the device out of the
mains outlet.
► Wait for about 3 minutes.
► Plug the power plug into a properly grounded
mains outlet again.
► Switch the device on.
Problem solutions and tips
27