Fujitsu ESPRIMO E4xx Operating Manual page 44

System expansions
Removing an accessible 5
► Remove the cover (see chapter
► Remove the front panel (see chapter
► Remove the drive cage (see chapter
► Turn the drive cage over.
► Undo the screws (1).
► Pull the drive out of the drive cage in the direction of the arrow (2).
► If necessary, make the required settings on the remaining hard disk drives.
► If you are not planning to install a new drive, install the corresponding drive cover in
the front panel (if available). To do this, insert the drive cover from behind into the front
panel and press the latches gently into their respective retainers.
► Install the drive cage (see chapter
► Secure the front panel on the casing (see chapter
► Install the cover on the casing again (see chapter
It may be necessary to modify the entry for the drive in the BIOS Setup.
40
/ inch drive (e.g. DVD drive)
1
4
"Removing a cover", Page
"Removing the front panel", Page
"Removing the drive carrier", Page
1
1
1
"Installing the drive cage", Page
33).
2
"Securing the front panel", Page
"Reattaching the cover", Page
34).
37).
38).
35).
36).
Fujitsu