Basic Operation; Projector On, Input Select Procedures - Wolf DCL-200 FD User Manual

DCL-200 FD

Basic Operation

Projector ON, INPUT Select Procedures

Connect the required external equipment to the projector before operating the following procedures.
Note: The language preset at the factory is English. If you want to change the on-screen display to another language, reset the
language according to the procedure on page 21.
1 Plug the power cords into the wall outlet.
The power indicator illuminates blue, and the
projector enters a standby mode.
2 Select the TV/Projector button, then the
POWER ON button.
The power indicator turns off.
3 Press the SCALER button, aim the remote at
the ProScaler and select the desired INPUT
1-10 via the remote control.
4 Press the POWER ON button on the remote
control, then press the center OK button
to turn off the projector whenever the
confirmation message is displayed.
Note: If you accidentally press power and do
not want to turn off the projector, press
Exit button or select No to turn off the
confirmation message.
20
1080p DLP LED Front Projector
Note: The power indicator light indicates the status of the LED.
• Blue: The power is ready.
• Blue Blinking: The Projector is powering up or down.
Projector Power ON Button
Press to turn the Projector on
TV/Projector Select Button
Press to enable all remote
functions for the Projector
Source Device Input Buttons
Press to directly select the
available components connected
to the ProScaler Processor
SCALER Button
Press to change remote from
projector controles to
ProScaler processor funtions
User's Manual
OK Button