Connecting The Projector And Proscaler - Wolf DCL-200 FD User Manual

DCL-200 FD
Wolf Cinema's DCL-200FD projector is optimized to work with the included ProScaler. The ProScaler and projector are carefully
calibrated at the factory to support all basic functionality "out of the box."
The projector uses one primary HDMI input, which accepts all incoming video signals as delivered from the ProScaler. The
ProScaler processes and routes the variety of source components via the input selected.
There are 10 video inputs on the ProScaler: 6 HDMI [one front panel], 1 Component, 1 Component/RGB, 1 S-Video and
1 Composite input.
For additional ProScaler operation details, refer to this guide and the separate user manual: WOLF CINEMA PROSCALER
USER MANUAL

Connecting the Projector and ProScaler

The following basic steps are to be performed to connect all source components, Projector and ProScaler:
1 Connect all sources to the inputs of the ProScaler. For additional details please see the ProScaler Owners Manual.
Note: HDMI input #6 is under the removable WOLF CINEMA logo plate on the panel front.
2 Connect the HDMI signal cable to projector: Connect your long run HDMI video signal cable between the ProScaler
video output directly to the Projector. Connect the Audio Only HDMI cable (pass through) to your surround sound
receiver or processor.
Connect HDMI cable from ProScaler to Projector.
12
1080p DLP LED Front Projector
Audio-only signal pass through. Connect
via HDMI cable to an available input on your
surround sound receiver or A/V processor
User's Manual