Table of Contents
Advertisement
SSA RAID Adapter Installation and User's Guide.
Chapter 3. Configuring SSA Subsystems
3.0 Chapter 3.
Configuring SSA Subsystems
Before new SSA disk drives can be used by the operating system, you must configure them into the SSA subsystem. You use the
configuration utility (which is provided on each of the diskettes supplied with the adapter) to do this. The actions that you must
perform are:
1. Accept the new disk drives into the subsystem
2. Configure disk arrays, if required
3. Attach the disk arrays or individual disk drives to your system.
The following sections describe the details of these actions.
Subtopics
3.1 Running the Configuration Utility
3.2 Accepting New Disk Drives
3.3 Creating an Array
3.4 Attaching Resources
_ Copyright IBM Corp. 1996
3.0 - 1
Advertisement
Table of Contents
