Table of Contents
Advertisement
Operation
Dimmer Curves
Software Information
Fixture Hours
Backlight
White Balance
-12-
This setting determines how fast the output of the COLORdash™ Batten-Quad 12
changes when you modify the values of the red, green, blue, amber, and dimmer faders.
This setting provides four different options to simulate the dimming curve of an
incandescent lighting product.
1. Go to the Dim Mode main level.
2. Select a dimmer curve (OFF, DIM 1, DIM 2, or DIM 3).
The output is proportional (linear) to the dimmer and RGBA channel
OFF:
values.
DIM1–DIM3: The output follows the dimmer and RGBA channel values based on the
corresponding dimmer curve, DIM 1 being the fastest and DIM 3 the
slowest.
This option shows what version of software the COLORdash™ Batten-Quad 12 is
running.
1. Go to the Info main level.
2. Select Version. (the version number will show on the screen)
This option shows the total amount of hours the COLORdash™ Batten-Quad 12 has
been turned on.
1. Go to the Info main level.
2. Select FixHours (the hours will show on the screen).
This setting allows you to set the amount of time the backlight on the COLORdash™
Batten-Quad 12 stays on after the last button is pressed on the control panel.
1. Go to the BackLite main level.
2. Select On, 10S, 20S, or 30S.
3. Press <ENTER>.
This setting allows you to select the white color shown by the COLORdash™ Batten-
Quad 12 when the DMX controller's red, green, and blue faders are set to 255.
1. Go to the White Balance main level.
2. Select a color: R (red), G (green), or B (blue).
3. Select a color value (125–255).
4. Repeat for each color.
When selecting White Balance, you will only be able to define the values of red,
green, and blue.
The values of red, green, and blue configured from White Balance will define the
color temperature shown when the RGB faders are set to 255.
COLORdash™ Batten-Quad 12 User Manual Rev. 3
Advertisement
Table of Contents
