Using Cliffnet Wizard Pro - Clifford Prime Level TWO Installation Manual

: If equipped with the optional Self-Powered SmartSiren 4, selection of this feature will
n
NOTE 2
cause the system to sound a few seconds of siren sound #1. Toggle the valet switch to the right to
turn on this sound or to the tight to turn it off. The system will then sound a few seconds of sound
#2. Repeat: right=ON, left=OFF for each of the six sounds.
: Two beeps indicate all remotes have been cleared from memory. You must now add
n
NOTE 3
new/existing remotes with the “Add new remote” feature and/or the “Other remote” feature.
:
n
NOTE 4 Immediately toggle to the right
turn off the ignition (you’ll hear 3 beeps to confirm program mode exit). You
ignition back on and then re-enter the new code. If the LED flashes on, the new code is set. If the
LED does not light, the two codes did not match and the system has reverted to the previous code.
: Permits arming with the remote of a G4 system on another vehicle. For example, to set the
n
NOTE 5
button of the other car’s remote to arm this system, select column 4, row 1, then press the
✱
button of the other car’s remote (you’ll hear one beep). Immediately press the
beeps). The button of the other remote will now arm this system. Then select row 4 of this same
✱
column to assign a different button to disarm.
: The features in this column allow control of the system with the remote of a G4 system
n
NOTE 6
on another vehicle. Select the function, then press the unused button or button combination on
the other remote that you want to use to perform that function on this system (you will then hear a
the beeps noted).
NOTE
remote that will arm the system (column 4, row 1) before these others will be accepted.
The CliffNet Wizard PRO software provides an intuitive access to all installer and end-user
features through a user-friendly, graphical user interface and provides extensive diagnostic
capabilities. See www.clifforddealer.com to download a free copy of the program (a #60-509
cable set is required to connect your Windows PC or palmtop to the G4 DataPort).
Installer-Programmable Features
1. Turn on the ignition.
2. Enter the factory preset valet/programming code of "2" by toggling the valet switch
(located behind the LED assembly) to the left two times, then to the right.
3. Hold the switch to the left. You'll hear one beep after about 3 seconds to indicate user
programming mode. KEEP HOLDING (about 12 more seconds) until you hear the
3-beep installer programming mode confirmation.
4. Select the feature column: Toggle the switch to the right the number of times indicated
for the column. Pause. You will hear the same number of horn beeps, confirming your
selection.
5. Within five seconds, select the feature row: Toggle the switch to the left the number of
times indicated for the row. You'll hear a beep each time to help you count.
6. If there is a NOTE for the selected feature, perform the actions noted.
7. Pause. You will hear either one or two beeps: two beeps = ON, one beep = OFF.
8. You can select another feature, or you can exit program mode:
a. To select another feature in that same column, repeat step 5 within the next five
seconds (after five seconds, three beeps indicate return to the "Feature Select" position).
b. To select a different feature column, repeat step 4.
c. To exit program mode, turn the ignition off (you'll hear three beeps and the LED will
turn off), or wait 60 seconds for the system to automatically exit program mode.
, then enter the new code,
: You must first set a button or button combination on the other car’s

Using CliffNet Wizard PRO

9
, then
wait for the two beeps
now turn the
MUST
✱
button again (two
✱