Audio Control/Setup; Speaker Setting; Switching Display; General Operation - Kenwood KDC-MP238 Instruction Manual

General Operation
Audio Control
G
~
1
Select the source to adjust
Press the [SRC) button.
2
Enter Audio Control mode
Press the [VOll knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
• Volume offset: Sets each source's volume as a difference
from the basic volume.
4 Adjust the Audio setup item
Turn the [VOL] knob.
S
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Subwoofer level* "SW l"I"L SUB" -15 - + 15
System
Q
"NATURAL/FLAT"/ Natural/Rock/Pops/Easy/
"ROCK"I"POPS"/ Top 40/Jazz/User setting
"EASY"I"TOP401TP40"/
"JAZZ"I"USER"
Speaker Setting
Fine-tuning so that the System
Q
value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY"/ "STBy" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Bass level "BAS l" I"L BAS" -8 - +8
Middle level "MID I"I"L MID" -8 - +8
Treble level "TRE l" I"LTRE" -8 - +8
Balance "BAl''I''Bl'' Left 15 - Right 15
Fader "FAD"I"FD" Rear 15 - Front 15
Exit Audio Control mode (Volume control mode)
'Function of KDC-MP238/MP238CR/MP208/138
G
~
• "USER": This appears when Bass level, Middle level, and
Treble level are adjusted. When "USER" is selected,
these levels are recalled.
OFF
For 5&4in. speaker
"SP OFF"I"SP-F"
"SP 5/4"/"SP-5"
4
Exit Speaker Setting mode
Press the [VOL] knob.
4
Adjust the Audio item
Turn the [VOll knob.
S
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob.
For 6&6x9 in. speaker
For the OEM speaker
"SP 6*9/6"/"SP-6"
"SP OEM"/ "SP-O"
Audio Setup
Function of KDC-MP23B/KDC-MP23BCR/KDC-MP20B
Switching Display
Setting the Sound system.
1
Select the source to adjust
Press the [SRCl button.
2
Enter Audio Setup mode
Press the [VOll knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Changing the information displayed.
1
Enter Switching Display mode
Press the center of the Control knob for at least
1 second.
"DISP SEL" is displayed.
2
Select the Display item
Press the right or left side of the Control knob.
In Tuner source
"FREQ" Frequency
"V-OFF"I"V-OF" -8 - +0 (AUX -8 - +8)
"LPF" 80/120/160/Through(OFF) Hz
Volume offset
Low Pass Fi Iter*
'Function of KDC-MP238/MP238CR/MP208/138.
Clock
"CLOCK"
6
I
KDC-MP238/CR/KDC-MP208/KDC-138/CR