Table of Contents
Advertisement
AS12A1VC-E
1/26/00 3:16 PM
Installing and Connecting the Indoor Unit Drain Hose
Care must be taken when installing the drain hose for the indoor unit to ensure that any condensation
water is correctly drained outside. When passing the drain hose through the 65 mm (2
drilled in the wall, check that none of the following situations occur.
The hose must
NOT slope
upwards.
To install the drain hose, proceed as follows.
1
If necessary, connect the 2-metre(79 inch) extension to the drain hose.
2
If you are using the extension, insulate the inside part of the extension
drain hose with a shield.
3
Pass the drain hose under the refrigerant piping, taking care to keep the
drain hose tight.
4
Pass the drain hose through the hole in the wall, making sure that it is
sloping downwards, as shown in the illustrations above.
The hose will be fixed permanently into position once the
whole installation has been tested for gas leaks; refer to
page 39 for further details.
Page 9
The end of the drain
Do NOT bend the
hose must NOT be
hose in different
placed in water.
directions.
I
NSTALLING THE
9
inch) hole
16
5 cm
less
Keep a clearance of
Do NOT place the
at least 5 cm/2 inch
end of the drain hose
between the end of
in a hollow.
the hose and the
ground.
Shield
Drain hose
I
U
NDOOR
NIT
Ditch
Extension drain hose
31
E-
Hide quick links:
Advertisement
Chapters
Table of Contents
