Using the magnify feature
1.
Press the MAGNIFY ON button on the remote
control.
The picture will be magnified, and the MAGNIFY
dialog will appear on the screen. When the MAGNIFY
ON button is pressed for the first time after the
projector is turned on, the picture will be zoomed by
1.5 times. On the dialog, triangle marks to show each
direction will be displayed.
2.
The display magnification of the projector switches in order
with every press of the MAGNIFY ON button.
For computer signals, HDMI
LAN, USB TYPE A or USB TYPE B ports
1.5 times 2 times 3 times 4 times 1 time
For video signals, s-video signals, component video signals or
TM
HDMI
(Component) signals
1.5 times 2 times 1 time
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magnification.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnification is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnification is active, the keystone distortion condition may vary.
It will be restored when the magnification is disabled.
● Some horizontal stripes might be visible on the image while magnification is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
TM
(RGB) signals, input signals from the
Operating
MAGNIFY
ON / OFF
buttons
31