Table of Contents
Advertisement
Connecting Wires
to
Terminals
19nition key
switch
ACC.. Ignition wire (Red)
. . Battery wire (Yellow)
Car fuse box
(Main fuse)
USB device
(commercially available)
USB connector
C
~
..
If
you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit, that
in turn may start a fire. Always connect those
wires to the power source running through
the fuse box.
Reverse sensor wire (Purple/White)
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Q
Connect to the vehicle's parking brake detection
~
switch harness.
Parking sensor wire (Light Green)
"-===1-t--~=......,..--~======~~~~--";~~~~~
For the sake of safety, be sure to connect the parking sensor.
To car light control switch
.- • Dimmer control wire (OrangelWhite)
• Steering remote control input (Light Blue/Yellow)
To steering remote
.~==....;;~=======~~========
~
To use the steering wheel remote control feature, you need to an
•
~
exclusive remote adapter (not supplied) matches your car is required.
• Mute wire (Brown)
Connect to the terminal that is grounded when either
the telephone rings or during conversation. •
Q
To connect the Kenwood navigation system,
~ consult your navigation manual.
Depending on what antenna you are using, connect either to the control • • Motor antenna control wire (Blue)
terminal of the motor antenna, or to the power terminal for the booster • =;=================~====
amplifier of the film-type or short pole type antenna.•
When using the optional power amplifier, • • Power control wire (Blue/White)
connect to its power control terminal.
(@2
If no connections are made, do not let the cable come out from the tab.
4
I
KVT-614
Advertisement
Table of Contents
