Lights; Light Switch; Rear Seat Belt Status Indicator - Mercedes-Benz C Class Owner's Manual

C-class
Hide thumbs Also See for C Class:
Table of Contents

Advertisement

E
To raise: slide the belt sash guide up-
wards.
The belt sash guide engages in various
positions.
E
To lower: press and hold release but-
ton 1.
E
Adjust the belt sash guide to the appro-
priate height.
E
Let go of release button 1 and make
sure that the belt sash guide has en-
gaged.
Please observe the information on wearing
e
seat belts correctly (
page 94).

Rear seat belt status indicator

i
The status indicator for the rear seat belts
is only available for certain countries.
The status indicator for the rear seat belts
tells you how many of the belt tongues are
inserted into the seat belt buckles. This
enables you to see whether the occupants
have fastened their seat belts.
You can see the following messages in the
multi-function display:
Vehicles with multi-function steering
wheel (4 buttons)
<
I
No rr.st.belt engaged
<
I
1 rr.st.belt engaged
<
I
2 rr.st.belts engaged
<
I
3 rr.st.belts engaged
Vehicles with luxury multi-function steer-
ing wheel* (12 buttons)
<
I
No rear seat belt engaged
<
I
1 rear seat belt engaged
<
I
2 rear seat belts engaged
<
I
3 rear seat belts engaged
You will see the rear seat belt status indi-
cator in the multi-function display for
about 30 seconds when you pull away and
drive above 9 km/h or when the rear-seat
passengers fasten or release their seat
belts.
Nur fuer internen Gebrauch
Nur fuer internen Gebrauch

Lights

Light switch

For reasons of safety, Mercedes-Benz rec-
ommends that you drive with the lights
switched on even during the daytime. In
some countries, daytime use of headlamps
varies due to legal requirements and self-
imposed obligations. In these countries,
dipped-beam headlamps are switched on
when the ignition is switched on. On ve-
hicles with a luxury multi-function steering
wheel*, you can use the on-board com-
puter to alter this setting in countries
where daytime driving lights are not legally
required, see the section on daytime driv-
e
ing lights (
page 137).
i
If you drive in countries in which traffic
drives on the opposite side of the road to the
country where the vehicle is registered, oncom-
ing traffic may be dazzled by the asymmetrical
dipped-beam headlamps. Have the headlamps
changed to symmetrical dipped beam when
driving in these countries. You can obtain infor-
mation about this from any Mercedes-Benz
Service Centre.
Controls
Lights
ee
97

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

C 200C 280C 350C 220 cdiC 320 cdi

Table of Contents