Radio Operation - Jensen MP1524BT Owner's Manual

Auxiliary Input
Open the front panel cover (14) to access the 3.5mm stereo auxiliary input
connector (12). An external device can be connected to the unit using the auxiliary
input connector (12). Plug the cable into the jack. Press the MODE/PAIR button
(5) on the front panel to switch to the AUX mode to access external devices. You
cannot directly control external devices connected to the auxiliary input jack.

Radio Operation

Switching to Radio Mode
Press the MODE/PAIR button (5) briefly to select the radio mode. The radio
frequency appears in the display together with the frequency memory band and.
Selecting the Frequency Band
In radio mode, press the BAND/LOUD button (4) briefly to select the desired band.
The reception band will change in the following order:
FM1
Selecting a Station
Press the button (8) or
function. Press for several seconds until MANUAL appears on the display; the
manual tuning mode is enabled. If both buttons have not been pressed for several
seconds, they will return to seek tuning mode and AUTO appears on the display.
Automatic Memory Storing
Press and hold the AS/PS * iPod®-MENU button (19) to access the Auto-Store
Tuning feature which will automatically scan and enter up to eighteen strong
stations into the six preset memory locations for FM1, FM2 and FM3 and twelve
strong stations into the six preset memory locations for AM1 and AM2. The radio
searches from the current frequency and checks the signal strength until one cycle
search is finished. The 6 stations with the strongest signals are stored into the
corresponding preset number button.
Station Storing
To set any of the 6 pre-set memories in each band, use the following procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the
Press for several seconds until MANUAL appears on the display; the manual
tuning mode is enabled.
3. Press the pre-set button to be set and continue to hold it in for approximately
2 seconds. The pre-set number, will appear on the display panel below the
frequency indication and a single beep will sound, indicating that the station
is now set into that pre-set memory position. The station can now be recalled
at any time by pressing that button.
18
FM2 FM3
button (9) briefly to activate the automatic seek
AM1 AM2
button (6) or
MP1524BT
button (18)