Installing The Unit - Jensen MP1524BT Owner's Manual

DIN Front Mount (Method A)
The unit can be installed in any dashboard having an opening as shown below:

Installing the unit

Be sure you test all connections first, and then follow these steps to install the unit.
1. Make sure the ignition is turned off, and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Remove the outer trim ring from the unit
4. The two supplied keys release tabs inside the unit's sleeve so you can remove
it. Insert the keys as far as they will go (with the notches facing up) into the
appropriate slots at the middle left and right sides of the unit. Then slide the
sleeve off the back of the unit.
5. Mount the sleeve by inserting it into the opening of the dashboard and bend
open the tabs located around the sleeve with a screwdriver. Not all tabs will
be able to make contact, so examine which ones will be most effective. Bend
open the appropriate tabs behind the dashboard to secure the sleeve in place.
4
(1) Outer trim ring; (2) Sleeve; (3) L key; (4) R key
MP1524BT