Options; Setting Convection Auto Conversion Feature; Thermostat Adjustment - LG LSB5682SS Owner's Manual & Cooking Manual

SETTING CONVECTION AUTO
CONVERSION FEATURE
When using convection bake, the Convection Auto
Conversion feature will automatically convert entered
regular baking temperatures to convection baking
temperatures.
This feature is activated so that the display will show the
actual converted (reduced) temperature. For example, if you
enter a regular recipe temperature of 350°F and press the
START pad, the display will show the converted
temperature of 325°F.
To set the feature ON/OFF
1. Press the COOK & WARM pad
for 3 seconds.
2. Press "5" pad. The display will
show "Auto On".
3. Press "5" pad to switch between
the "On" and "OFF".
4. Press START pad to accept the
desired change.
OPERATION (OPTIONS)
- 17 -

THERMOSTAT ADJUSTMENT

The temperature in the oven has been preset at the factory.
When first using the oven, be sure to follow recipe times and
temperatures. If you think the oven is too hot or too cool,
the temperature in the oven can be adjusted. Before
adjusting, test a recipe by using a temperature setting that is
higher or lower than the recommended temperature. The
baking results should help you to decide how much of an
adjustment is needed.
The oven temperature can be adjusted from -35°F(-19°C) to
35°F(19°C) .
The thermostat adjustments made with this feature
Note:
will just change Bake, Convection Bake and
Convection Roast temperature.
To increase the oven temperature:
1. Press and hold "BAKE" pad for 3
seconds.
2. To increase the temperature use
the number pads to enter the
desired change.
(Example 20°F : 2, 0).
"20°" will be displayed.
3. Press START to accept the
temperature change and the
display will return to the time of
day. Press CLEAR/OFF to reject
the change if necessary.
To decrease the oven temperature:
1. Press and hold "BAKE" pad for 3
seconds.
2. To decrease the temperature use
the number pads to enter the
desired change.
(Example -20°F : 2, 0) and then
press BAKE pad once.
"- 20°" will be displayed.
3. Press START to accept the
temperature change and the
display will return to the time of
day. Press CLEAR/OFF to reject
the change if necessary.