LG LRE30955S Installation Manual
Electric range
Hide thumbs
Also See for LRE30955S:
- Installation manual (11 pages) ,
- Installation manual (10 pages) ,
- Installation manual (12 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for LG LRE30955S
Summary of Contents for LG LRE30955S
- Page 1 Website: http://us.lge.com Electric R ange LRE30955S / LRE30855S LRE30755S / LRE30451S ..these instructions thoroughly before ............. i taJJi_ Bdoperafingtherange. JJJJJii_, P/No.: MFL37118101...
-
Page 2: Important Safety Instructions
BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range. -
Page 3: Prepare To Install The Range
PREPARE TO INSTALL THE RANGE TOOLS NEEDED • The information in this manual should be followed exactly. Phillips Screwdriver Level - A fire or electrical shock may result causing property damage, perasonal injury or death. Flat-blade Adjustable Wrench Screwdriver • DO NOT step or sit on oven 1/4"... -
Page 4: Installation
INSTALLATION DRAWINGS NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than lS/32 (12ram) from any adjacent surface. -
Page 5: Electrical Connection Requirements
ELECTRICAL CONNECTION CONNECT RANGE CORD REQUIREMENTS The Rear Access cover must be removed. Loosen the three screws with a screwdriver. The terminal block This appliance must be installed and grounded on a will then be accessible. branch circuit by a qualified technician in accordance with the National... - Page 6 CoaSt • The middle (neutralor ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to ,,'_CSnduit_'', be connected to the outside posts of the connection',...
- Page 7 Install the conduit as follows: Remove the Conduit connection plate from the rear of drawer body and rotate it as shown in Figure 5. The • Only a 4-conductor power-supply cord kit conduit hole (1%") must be used. rated 120/240 volts, 50 amperes and marked for use with ranges with closed- First, prepare conduit wires as shown in Figure 10.
- Page 8 1. Follow the instructions under "Install the conduit 4-wire connection follows" on page 7 to correctly install the strain relief. Black White You must install the conduit with a strain relief. Terminal 2. Loosen the 2 lower left and right screws from the block terminal block.
-
Page 9: Anti-Tip Device Installation
Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws. range Access [6......Use a spirit level to check your adjustments. Place the level diagonally on the oven rack, and check each direction...