6
UltraView PTZ
User Manual
Top-level access and information screens
When you access the UltraView PTZ series, the following three menus display:
Password. The camera will come from the factory with the
default password turned off, but saved in memory. See
Passwords
on page 42 for details. If you have previously
input some information to set up the camera and have
passwords enabled, you will be prompted to enter your
password (Figure 3) to proceed. Use the directional buttons
to navigate to the numbers, and press iris + to input those
numbers. Input the wrong password and you will
automatically exit the menu. If the password is correct, you
will proceed to the
Product information. This screen (Figure 4) provides
product information, including:
•
Product name
•
Camera type
•
Site ID number
•
Unit serial number
•
Installation date (This should be set by the installer.)
•
Video format
•
Protocol
There are no customizable options on this screen. Go to the
next screen by pressing fast forward on the keypad.
System information. This screen (Figure 5) provides
information pertaining to the current software, hardware, and
installation information.
P =
Type and version date for the pan processor.
T = Type and version date for the tilt processor.
B = Camera type and firmware version.
I =
Type and version date for the housing card.
Note: If you see no type and version date info, verify proper
connections, mounting, and presence of the housing card.
If there is no housing card, you will see the message,
"I: NOT INSTALLED."
There are no customizable options on this screen. Go to the
next screen by pressing fast forward on the keypad.
Product information
screen.
Figure 3. Password screen
ULTRAVIEW PTZ
Figure 4. Product information for UltraView PTZ
ULTRAVIEW PTZ
DAY/NIGHT 27X WDR
-- SITE 0083 --
SERIAL :
INSTALLATION :
VIDEO FORMAT : NTSC
PROTOCOL :
EXIT HOLD SEQ
Figure 5. System Information for UltraView PTZ
ULTRAVIEW PTZ
B: LM703n-8 V 1.48
NEXT
091217
091217