Installation; Connecting The Units; Installation Connecting The Units - Pioneer AVH-5400DVD Owner's Manual

Section
12

Installation

Connecting the units

WARNING
! To avoid the risk of accident and the potential
violation of applicable laws, no viewing of
front seat video should ever occur while the
vehicle is being driven. Also, rear displays
should not be in a location where they are visi-
bly distracting to the driver.
! In some countries or states the viewing of
images on a display inside a vehicle even by
persons other than the driver may be illegal.
Where such regulations apply, they must be
obeyed and this unit's DVD features should
not be used.
CAUTION
! PIONEER does not recommend that you in-
stall or service your display unit yourself. In-
stalling or servicing the product may expose
you to risk of electric shock or other hazards.
Refer all installation and servicing of your dis-
play unit to authorized Pioneer service person-
nel.
! Secure all wiring with cable clamps or electri-
cal tape. Do not allow any bare wiring to re-
main exposed.
! Do not drill a hole into the engine compart-
ment to connect the yellow cable of the dis-
play unit to the vehicle battery. Engine
vibration may eventually cause the insulation
to fail at the point where the wire passes from
the passenger compartment into the engine
compartment. Take extra care in securing the
wire at this point.
! Make sure that cables will not interfere with
moving parts of the vehicle, such as the gear-
shift, parking brake or seat sliding mechan-
ism.
! Do not shorten any cables. If you do, the pro-
tection circuit may fail to work properly.
WARNING
! LIGHT GREEN LEAD AT POWER CON-
NECTOR IS DESIGNED TO DETECT
PARKED STATUS AND MUST BE CON-
46
En
NECTED TO THE POWER SUPPLY SIDE
OF THE PARKING BRAKE SWITCH. IM-
PROPER CONNECTION OR USE OF
THIS LEAD MAY VIOLATE APPLICABLE
LAW AND MAY RESULT IN SERIOUS IN-
JURY OR DAMAGE.
Important
! This unit cannot be installed in a vehicle with-
out ACC (accessory) position on the ignition
switch.
! Use of this unit in conditions other than the
following could result in fire or malfunction.
— Vehicles with a 12-volt battery and negative
— Speakers with 50 W (output value) and
! To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
— Disconnect the negative terminal of the
— Secure the wiring with cable clamps or ad-
— Place all cables away from moving parts,
— Place all cables away from hot places,
— Do not connect the yellow cable to the bat-
— Cover any disconnected cable connectors
— Do not shorten any cables.
— Never cut the insulation of the power cable
— Use a fuse of the rating prescribed.
Autogood products «130»
ACC position
grounding.
4 ohm to 8 ohm (impedance value).
battery before installation.
hesive tape. Wrap adhesive tape around
wiring that comes into contact with metal
parts to protect the wiring.
such as the gear shift and seat rails.
such as near the heater outlet.
tery by passing it through the hole to the
engine compartment.
with insulating tape.
of this unit in order to share the power
with other devices. The current capacity of
the cable is limited.
No ACC position