Selecting The Video Format; Setting The Video Signal - Pioneer AVH-5400DVD Owner's Manual

Section
10 Menu operations
2 Touch Camera Polarity on the system
menu to select the appropriate setting.
! Battery – When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
! Ground – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit

Selecting the video format

You can switch the video output format of
REAR MONITOR OUTPUT between NTSC and
PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 28.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC—PAL
Note
You can switch the video output format only for
the source from this unit.

Setting the video signal

When you connect this unit to an AV equip-
ment to this unit, select the suitable video sig-
nal setting.
! As this function is initially set to Auto, the
unit will automatically adjust the video sig-
nal setting.
! You can operate this function only for the
video signal input into the AV input.
1 Display the system menu.
Refer to Introduction of menu operations on
page 28.
2 Touch Video Signal Setting on the func-
tion menu.
Video Signal Setting items are displayed.
40
En
! AV – Adjusts the AV video signal
! AUX – Adjusts the AUX video signal
! Camera – Adjusts the rear view camera
video signal
3 Touch c or d to select the desired
video signal appears.
Auto—PAL—NTSC—PAL-M—PAL-N—
SECAM
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures
the car's interior acoustic characteristics, and
then creates an auto-equalizer curve based on
that information.
WARNING
As a loud tone (noise) may be emitted from the
speakers when measuring the car's interior
acoustic characteristics, never perform auto EQ
while driving.
CAUTION
! Thoroughly check the conditions before per-
forming auto EQ as the speakers may be da-
maged if these functions are performed when:
— The speakers are incorrectly connected.
— A speaker is connected to a power amp de-
! If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in battery drainage. Be sure to place
the microphone in the specified location.
Autogood products «130»
(For example, when a rear speaker is con-
nected as a subwoofer output.)
livering output higher than the speaker's
maximum input power capability.