Table of Contents
Advertisement
Available languages
Available languages
RFP Alert Installation
ALARM OUTPUT (Brown)
m Recommended Wiring:
30 amp relay (sold separately) required to operate siren. horn or lights.
* Connect Brown wire to one side of relay coil.
* Connect ground to other side of coil.
For sirens, horns or lights requiring +12 V trigger
* Connect normally open to fused. constant +12 V source.
For horns or lights requiring ground trigger
* Connect normally open pin to ground.
This Product
White/Orange trefer to "DOOR LOCK™.)
White/Red (refer to "ALARM
SENSOR™.)
White (reter to "DOOR SWITCH")
RELAY
|
(sold separately)
30 A Fuse
ae
CONTROL
(sold separately)
(= OF
120A
|
BATT
OUTPUT
f
\
i
i
—
GND
| i
Horn/Siren etc.
Le
' Car battery
'{-+--—————-
—
Fig. 5
ALARM SENSOR (White/Red)
Note:
+ Lf the shock sensor detects vehicle vibrations, use the negative (-) output type. If you use
the posi-
tive (+) output type. the alert will sound continually, and the shock sensor will not operate
correctly.
This Product
Glass Sensor
Brown (reter to "ALARM
OUTPUT")
==
White (refer to "DOOR SWITCH™.)
Shock Sensor
(Ensure proper sensitivity adjustment in
accordance
with
muker's
instructions.)
Fig. 6
Precaution:
* To ensure full and proper operation of RFP Alert, Pioneer suggests using only White/Red wire,
electronic sensors capable of providing a pulse width greater than 64 ms.
Advertisement
Table of Contents
