Boiler Jacket Assembly - Biasi B-3 Manual And Installation Instructions

NOTE: Prior to installing the casing, make note of the boiler serial number located
on the left front leg of the boiler. All piping, boiler controls, gauges and valves
should be installed before the jacket is assembled on the boiler. Below is an
explosion view of the boiler and jacket assembly to clarify these boiler jacket
assembly instructions. Insert the separate (loose) piece of insulation on top of boiler
with the foil side facing in so the entire top, bottom and sides of boiler are covered.
Place tubular jacket spacers (#35 & #36 on exploded view of boiler) on the upper
and lower draw rod extensions at the front(long spacers) and rear(short spacers) of
the boiler. Place the rear insulated jacket panel (#26) at the back of the boiler, by
slipping the predrilled holes over the tie rods. Position side jacket panels (#38 &
#25) by slipping the slotted cut-outs over the boiler draw rods. Place the lower front
jacket panel (#28) in place and secure with self-tapping screws provided. Fasten
the washers and hex nuts to the ends of the tie-rods to hold the jacket in place. Set
the top panel (#27) in place and secure with two screws in the back of the panel.
With the jacket firmly secured, place front panel (#37) in position on the tabs on the
side panels and press firmly to snap spring connectors in place.
NOTE: Do not attach any electrical wiring or electrical conduit or boiler piping to the
top panel (#27).
Note: For replacement parts, contact your local B10 wholesaler.

Boiler Jacket Assembly:

25 RH Side Jacket Panel
26 Rear Jacket Panel *
27 Top Jacket Panel
28 Lower Front Jacket Panel
29 Top & Side Insulation
30 Front Panel Pin Clips
31 Self Tapping Screws (Qty 2)
32 Jacket Mounting Nut (Qty 8)
33 Jacket Mounting Washer (Qty8)
34 Front Panel Mounting Pins
35 Long Jacket Spacer (Qty 4)
36 Short Jacket Spacer (Qty 4)
37 Front Jacket Panel *
38 LH Side Jacket Panel
* Supplied with attached insulation
10. Boiler Jacket Assembly
Page 21