Important Information - Biasi B-3 Manual And Installation Instructions

B10 series atmospheric venting

Hide thumbs

Table Of Contents

Table of Contents



ALL BOILERS MUST BE INSTALLED IN ACCORDANCE WITH NATIONAL, STATE AND LOCAL

PLUMBING, HEATING AND ELECTRICAL CODES AND ORDINANCES, AS WELL AS THE

REGULATIONS OF THE SERVING ELECTRICAL, WATER AND GAS UTILITIES.



All systems should be designed by competent licensed heating contractors,

and only persons knowledgeable in the layout and installation of heating

systems should attempt the installation of the B10 boiler. It is the

responsibility of the installing contractor to see that all controls are correctly

installed and operating properly when the installation is completed.



Do not burn volatile garbage, gasoline, naphtha or other flammable liquids

other than No. 2 fuel oil. All flammable liquids (especially gasoline), chemicals,

rags, paper, wood scraps, debris, etc., should be kept away from the boiler at

all times. Keep the boiler area clean and free of all fire hazards.



Please read the literature and warranties supplied by the manufacturers of the

various accessory equipment. This equipment is warranted by the respective

manufacturers, not by Quincy Hydronic Technology, Inc. Each piece of

equipment must be installed and used according to the recommendations of

the manufacturer.

Codes and Regulations:

Installation of the boiler, burner, oil tank and related equipment must conform to

national, state and local regulating agencies and codes applicable to the installation of

the equipment. In the absence of local requirements, the following codes apply:

A. NFPA

B. NFPA

C. NFPA

D. ANSI

E. ANSI

F. CAN/CGA - B149 Installation Codes

G. ANSI

H. CSA

The above codes are available from:

National Fire Protection Association

(NFPA)

Battery March Park

Quincy, MA 02269

http://www.nfpa.org

Page 4