D-Link DFE-650 Series User Manual page 39

Proceed as follows:
1. Exit Installation Director. Examine the CONFIG.SYS file in
the root directory of your notebook PC's startup drive (hard
drive).
statement for Extended Memory Manager (EMM). Such a
statement should resemble the following example,
DEVICE = C:\DOS\EMM386.EXE X=D000-D7FF
2. If there is no similar DEVICE statement in your notebook
PC's CONFIG.SYS file, then edit the CONFIG.SYS file,
adding a statement copied exactly from the above example.
3. If there such a statement in CONFIG.SYS but the "DFE-650
PC Card not detected" error appears on each attempted Quick
Install run anyway, then edit that statement to read exactly the
same as the above example.
4. If, after you have completed the above instructions, the "DFE-
650 PC Card not detected" error still appears on each
subsequent restart of the notebook PC, then please contact
your dealer or your nearest D-Link office, as listed at the end
of this User's Guide.
You need to "unload the conflicting network driver"
You are running Installation Director, and in the Main Menu you
have selected
Quick Install 16-bit Driver for Dos Netware
Then you have seen the warning message which advises that the
presence in memory of another network card driver could cause a
system halt. (That warning messages appears in every Quick Install
run –– it does not indicate that there is another network card driver
already loaded into memory.) Then you have elected to continue
Troubleshooting
DFE-650 Series Fast Ethernet PC Card User's Guide
Ascertain that CONFIG.SYS contains a DEVICE
Client.
31