D-Link DFE-650 Series User Manual page 27

DFE-650 Series Fast Ethernet PC Card User's Guide
Navigate to the appropriate directory in your Client32 source, so
that it is your active directory, and find INSTALL.EXE in that
directory. Then at the DOS prompt (shown here as ), type:
>
> INSTALL.EXE
and . Following the copyright notice screen, the next
<Return>
screen in the INSTALL.EXE run will be the "Select the products"
screen.
"Select the products" Screen
This screen offers simultaneous installation of several network
software packages. NetWare Client 32 for DOS appears at the top
of the list. Follow the on-screen instructions, and select the
checkbox at the left of NetWare Client 32 for DOS:
[X] NetWare Client 32 for DOS
For the purpose of basic LAN operations, it is not necessary to
select any of the other products. If you are in doubt whether any of
the other packages offered by this screen should be included in your
installation, then consult your LAN administrator. After the proper
selections are made (marked with an X), key <F10> to continue.
"Select a LAN Driver Type" Screen
In this screen, use the up or down arrow keys to highlight
32-bit LAN drivers
Then key <F10> to continue.
"32-Bit Network Board Drivers" Screen
Use the down arrow key, or the Page Down key to scroll to the
bottom of the long list of driver modules (drivers which are
included with the NetWare software). At the bottom of the list,
19
Software Installation