Table of Contents
Advertisement
FIG. 65
Site Survey of available WAPs (Secured WAP shown selected)
8. Press the SSID field and from the Network Name (SSID) keyboard, enter the SSID name you are
using on your target Wireless Access Point (case sensitive), and press Done when finished.
9. Toggle the Encryption field (FIG. 64) until it reads either: 64 Bit Key Size or 128 Bit Key Size.
The 64/128 selection reflects the bit-level of encryption security. This WEP encryption level must
match the encryption level being used on the WAP.
WEP will not work unless the same Default Key is set on both the panel and the
Wireless Access Point.
For example: if you have your Wireless Access Point set to default key 4 (which
was 01:02:03:04:05), you must set the panel's key 4 to 01:02:03:04:05.
10. Toggle the Default Key field until the you've chosen a WEP Key value (from 1- 4) that matches
what you'll be using on your target WAP200G. This value MUST MATCH on both devices.
11. With the proper WEP Key value displayed, press the Generate button to launch the WEP
Passphrase keyboard.
If you are wanting to have your target WAP (other than an NXA-WAP200G) generate the
Current Key - Do not press the Generate button and continue with Step 13.
7" Modero Touch Panels
Manually entering the SSID information into the appropriate field by following step 8.
The card should be given the SSID used by the target WAP. If this field is left blank, the unit
will attempt to connect to the first available WAP. By default, all WAP200Gs use AMX as
their assigned SSID value.
One of the most common problems associated with connection to a WAP arise because the
SSID was not entered properly. You must maintain the same case when entering this
information. ABC is not the same as Abc.
The alpha-numeric string is by default AMX but can later be changed to any 32-character
entry. This string must be duplicated within the Network Name (SSID) field on the WAP.
As an example, if you use TECHPUBS as your SSID, you must match this word and the
case within both the Network Name (SSID) field on the touch panel's Network Name SSID
field and on the WAP's Basic Wireless Configuration page.
These WEP Key identifier values must match for both devices.
This keyboard allows you to enter a Passphrase (such as AMXPanel) and then
AUTOMATICALLY generate a WEP key which is compatible only among all Modero panels.
Configuring Communication
Select a target
WAP with the
desired level of
security
Connecting to the
WAP begins the
communication
65
Advertisement
Table of Contents
