Speaker & Rca Connections; 2-Channel-Mode Stereo Front- Or Rearsystem - Hifonics TXi 4000 Owner's Manual

Speaker & RCA Connections

2-Channel-Mode Stereo Front- or Rearsystem

RCA & Speaker wiring:
• Connect the LINE INPUT of the amplifier to the head unit line output with appropriate good quality RCA cables.
• Connect the speakers with appropriate wires to the terminal block (SPEAKER OUTPUT - CH1 + and - CH2 +) of the amplifier.
• The minimum final speaker impedance must not be lower than 2 Ohms per channel. Too low speaker loads result in too high
heat dissipation and may cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal
Do not connect speaker (-) to the ground or vehicle's chassis.
Left Speaker
2 - 8 Ohm
X-Over Switch
• By using bigger speaker systems (20cm), set the switch on FULL-position (FULL RANGE Signal).
• By using smaller speaker systems (8.7cm - 16cm), set the switch on HP-position (HIGH PASS Signal).
The cut-off frequency should be between 60Hz - 150Hz. Adjust the level by the LOW PASS-contoller.
• In this configuration the LOW PASS - Mode is out of function.
Input Level
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80% - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
Bass EQ
• This controller should be set to 0dB-position.
Bass Remote
• The provided Bass Remote is not required in this configuration.
16
TXi 4000 / TXi 6000
Caution!
Right Speaker
2 - 8 Ohm
Connect RCA cable (CH1/2) from head-unit with
RCA input (CH1/2 L/R LINE INPUT).
18