Speaker- & Rca Connections 2-Channel-Mode / Stereo Front- Or Rearsystem - Hifonics Titan TXi 5400 Owner's Manual

Speaker & RCA Connections
2-Channel-Mode Stereo Front- or Rearsystem
RCA & Speaker wiring:
• Connect the LINE INPUT of the amplifier to the head unit line output with appropriate good quality RCA cables.
• Connect the speakers with appropriate wires to the terminal block (SPEAKER OUTPUT/ - CH1 + and - CH2 +) of the amplifier.
• The minimum final speaker impedance must not be lower than 2 Ohms per channel. Too low speaker loads result in too high
heat dissipation and may cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal
Do not connect speaker (-) to the ground or vehicle's chassis.
Left Speaker
2 - 8 Ohm
X-Over Switch
• For bigger speaker systems (Ø 20cm), set the switch to FULL-position (FULL RANGE mode).
• For smaller speaker systems (Ø 8.7cm - Ø16cm), set the switch to HP-position (HIGH PASS mode).
The cut-off frequency can be selected with the HIGH PASS-contoller.
• In this configuration the LOW PASS - controller is not required.
Level
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80 - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
Bass EQ
• This controller should be set to 0dB-position.
Bass Remote
• The provided Bass Remote is not required in this configuration.
16
TXi 4000 / TXi 6000
Caution!
Right Speaker
2 - 8 Ohm
Connect RCA cable (CH1/2) from head-unit with
RCA input (CH1/2 L/R LINE INPUT).
18