How To Operate The Heater; To Turn The Heater On; To Adjust Set Temperature - Rinnai Avenger 25 Operation Manual

HOW TO OPERATE THE HEATER

Avenger Blaze Dynamo
Enduro

TO TURN THE HEATER ON

Before you begin, ensure that the Gas and Power have been connected correctly to the appliance.
To turn the appliance on press the ON/OFF button
are equipped with a remote control the ON button
When pressed the appliance will begin to operate in the following factory preset manner:
• The default set temperature will be 22° C
• The current room temperature will be displayed
• The On/Combustion indicator
The ON/Combustion indicator will change to Red (steady) after proper ignition has been
achieved to signify the correct burner operation.
When using the appliance for the first time or after long periods of disuse, ignition may
not occur the first time it is operated as there may be air within the pipes. If ignition
does not occur after approximately 30-seconds the unit will cease operation
NOTE
automatically. If this occurs press the ON/OFF button
that are equipped with a remote control the press the OFF button
the ON button
The unit may make noises after ignition/extinction. This is due to expansion and
contraction of the heater components and is normal.
The heater will not immediately ignite if the ON/OFF button
extinction. After approximately 20 seconds has passed, the heater will automatically
go into ignition mode.

TO ADJUST SET TEMPERATURE

The set temperature may be raised or lowered by use of the Up and Down buttons
control panel. For models that are equipped with a remote control the Up and Down buttons
also be used.
The following "SET" temperatures can be selected.
• 'L' for continuous combustion on lowest burner setting, without thermostatic control.
• Thermostatic control between 16º C to 26º C in 1º C steps
• 'H' for continuous combustion on highest burner setting, without thermostatic control.
The room temperature will display temperatures between 1º C to 30º C.
Once the temperature is set it will be stored in the microcomputers memory, if the temperature is not
adjusted further it will be available as the initial setting when the appliance is next used.
Rooms may not arrive at the "SET" temperature due to the size and construction of
the room, location of the appliance or external temperatures.
NOTE
If the appliance does not ignite then the actual room temperature may be higher than
the pre-set temperature selected.
Operation Manual
15
33
.
15
will illuminate Green (steady). Ignition will take 5 ~ 10 seconds.
12
to restart.
39
13
17
31 13
located on the control panel. For models that
2
may also be used.
39
, /
17 31 33
twice to restart. For models
9
39
ON
OFF
40
41
2
12
2
12
and then press
40
is pressed straight after
located on the
13
may
41
Rinnai