To Empty The Tank-In-Tank; To Fill The Tank-In-Tank - Bissell 1694 SERIES User Manual

To Fill The Tank-in-Tank

This easy-to-use system is designed with a bladder
inside to hold clean water. As you clean, the bladder
will empty. Dirty water collects in the tank outside the
bladder.
NOTE: Make sure to add formula to the tank before
filling it with water.
Depress the Handle Release pedal to tilt back the handle.
1.
Lift the Tank-in-Tank™ handle. The handle locks the lid in
2.
place. Carry the Tank-in-Tank™ like a bucket to fill at the sink.
Set the Tank down and rotate the handle forward to
3.
unlatch the Lid. Lift off and set the Lid aside.
Using the Measuring Cup, pour BISSELL Deep Cleaning
4.
Formula into the mouth of the bladder.
Fill to the bottom of the neck with hot tap water. Do not
5.
boil or microwave water.
NOTE: Fill slowly to reduce sudsing.
Replace the Tank Lid, matching the Lid and Tank edges.
6.
Rotate the handle to carrying position. Replace Tank in
machine base, seating firmly in place. Rotate handle back
down to latched position.
When It's time To Empty The Tank-in-Tank
NOTE: Remove the Tank-in-Tank, following
steps 1 and 2 at the top of the page.
Carry the Tank-in-Tank, like a bucket, to the sink. Remove
1.
Tank Lid. Pour out dirty water.
After each use, remove and rinse the Lint Screen located
2.
on the Tank Lid.
A. Remove Tank Lid.
B. Remove Lint Screen and rinse under faucet. Remove
any debris caught in Lint Screen.
C. Re-insert Lint Screen on Tank Lid. The screen will
click into place.
D. Replace Tank Lid.
Refill with cleaning solution and clean tap water—follow
3.
steps 3-5 above.
When a cleaning job is complete, rinse out the Tank-in-Tank
4.
by running clean water between the bladder and the tank.
Return the Tank-in-Tank to the machine, follow
5.
step 6 above.
Refer to the Maintenance/Storage section on the next
6.
page for final cleanup.
6.
Tilt Handle Back
1 2
Handle Release
Rotate Handle
to Unlatch
3
5
Lint Screen
1
Lint Screen
2C
5
Tip:
A special red float device in the
tank will cause the cleaner to
stop removing solution from the
carpet. The motor sound will
rise in pitch to let you know the
dirty water tank is full.
Lift and Carry
4
4
2B
Latched