Baffl E Removal And Installation; Fan Replacement - Heatilator C40 Owner's Manual

4. Baffl e Removal and Installation
WARNING! Hot Surfaces!
Glass and other surfaces are hot during operation AND cool
down. DO NOT clean fi replace until it is cooled.
• Remove all ash from fi rebox and place into a metal
container.
• Remove the baffl e protection channel by turning
it down and pulling it out of the firebox. See
Figure 4.5.
Figure 4.5 Removing Baffl e Protection Channel
• Remove ceramic blanket from above the baffl e.
• With a 3/16 in. Allen wrench, remove the front
manifold tube retainer bolt on the air channel under
the end of the front tube. See Figure 4.6.
Figure 4.6 Removing Manifold Tube
NOTICE: Soak the bolt with penetrating oil for at least
15 minutes before trying to remove it.
• To remove manifold tube, slide the tube to one side
until one end is out of its hole. Then, while lifting
that end of the fi ber board baffl e, pull tube up over
the air channel and out of hole at the other end. It is
only necessary to remove the fi rst tube in order to
remove the baffl e.
• Slide fi ber board baffl e forward to front of fi replace
and straight out through door. See Figure 4.7.
• To install the fi ber board baffl e, repeat the 2nd
through 4th steps in reverse. Be sure the fi ber board
baffl e and ceramic blanket are pushed back fully and
the blanket is down and fl at.
Heatilator • Constitution Owner's Manual • 480-2330 • Rev B 1-29-13
Figure 4.7 Removing Baffl e (shown without ceramic blanket)

5. Fan Replacement

CAUTION! Risk of Shock!
ing off circuit breaker before servicing.
CAUTION! Risk of Shock!
• DO NOT remove grounding prong from plug.
• Plug directly into properly grounded three-prong
receptacle.
• Route cord away from fi replace.
• DO NOT route cord under or in front of fi replace.
The 7100FP Fireplace comes equipped with two fans,
installed at the factory with electric access on the right
side of fi replace (as you face it).
• Fan Replacement Instructions
- Remove both doors, outside air knob, black knob
and fascia. Place fascia on protected surface.
- Remove the six center bricks from the bottom of
the fi replace.
- Remove the two screws from the access panel
in the fi rebox fl oor. See Figure 4.8. Pry up panel
with screwdriver and remove panel.
Screwdriver Slot
Figure 4.8 Accessing Fan Motor
Disconnect power by turn-
Screws
21