Table of Contents
Advertisement
•
.~----··--··
4
Press the shutter release button fully.
Set the focus mode to
MF
when the shutter cannot be released.
The screen to select the measuring range is displayed.
5
Use the rear e-dial
("#~.:-)
to select
the entire screen or spot area for
the measuring range.
D
o
OK
6
When a spot area is selected, use the four-way controller
{ .. T ,.... ...,. )
to move the frame to the position you want to
measure.
II[§)
J
Press the
OK
button.
8
The white balance is measured, and the screen that was displayed in
Step 3 appears again.
Adjust the white balance as necessary.
The message [The operation could not be completed correctly] appears
when measuring is unsuccessful. Press the
OK
button to remeasure the
white balance.
Press the
OK
button twice.
The camera is ready to take a picture.
tr~;~o
•
If a picture is extremely overexposed or underexposed, the white balance
may not be adjusted. In this case, adjust exposure to the correct amount level
before adjusting the white balance.
• When the mode dial is set to
~!!
(Movie), the white balance cannot be
measured. Adjust the white balance in any exposure mode other than
~!!
before recording a movie.
Advertisement
Table of Contents
