Placing Transparencies; Using The Universal Glass Plate - AGFA Horizon Ultra Scanner Owner's Manual

Placing transparencies

Using the universal glass plate

You can clip your originals underneath the universal glass plate and
place them on the glass plate of the scanner. Center the originals on
the glass plate, with their top side towards the calibration slot. This
position guarantees the best quality. Make sure that the calibration
slot in the frame is at the left side (standing in front of the scanner)
and that it is clean.
calibration slot
Figure 1-8
Placing a transparent original
If you place more than one slide on the glass plate (for batch
scanning), position them as close to the center line as possible to
optimize quality.
Chapter 1 — Preparing the scanner 19