Scanner Calibration - AGFA Horizon Ultra Scanner Owner's Manual

Scanner Calibration

With this tool the focus of the scanner can be optimized.
1. Put the calibration target on the glass plate of the scanner.
2. Make sure the text "Keep me clean" is readable from the top
side of the plate.
3. Double click the Scanner Calibration tool on your Macintosh.
4. Click Do to start the calibration.
The scanner calibration takes about 10 to 15 minutes to complete.
It is important to check that the calibration continues beyond the first
prescan. The prescan is used to check if the registration target is squarely
located (relative to the rulers).
If the target does not meet the requirements of the prescan, the tool will
exit with an error very shortly after the prescan has finished.
Chapter 3 — Calibrating the scanner 36