Replacing The Fuse - AGFA Horizon Ultra Scanner Owner's Manual

6. Disconnect the wires. Cut the cable binders.
7. Connect the new lamp.
8. Bring the new lamp in place by holding the wires.
Warning: Do not touch the glass with your bare hands. This would
dramatically shorten the new lamp's lifetime.
9. Re-assemble everything in reverse order.
Note: If you want to do the replacement yourself with a minimum of
wasted time, you can order a spare lamp before your transparency lamp
needs replacing.

Replacing the fuse

Replacement of the fuse should preferably be done by your dealer or
Agfa service representative. In case of an emergency, you can replace
the fuse as follows:
1. Disconnect the main power cable.
2. Locate the fuse(s) in the bottom left corner at the rear of the
scanner.
3. Replace the defective fuse(s).
For a 230 V scanner, you need 2 x 5 AMP slow blow fuses. For a
115 V scanner, you need a 10 AMP medium blow fuse.
Warning: Do not open the scanner housing. There are extremely sensitive
components inside the scanner.
Chapter 4 — Caring for your scanner 43