Connecting The Scanner - AGFA Horizon Ultra Scanner Owner's Manual

The documentation supplied with your PS/2 for information
on installing a SCSI adapter card.
If you are using third party software, check the
documentation supplied with that software for the SCSI
adapter cards supported.
Your PS/2 computer also needs a configuration file to make it aware
of the interface card. This file enables your computer to automatically
configure the interface card.
Make sure that the Adapter Description File that came with your SCSI
interface card has been copied to your PS/2 Reference diskette.

Connecting the scanner

Before you connect the scanner to your PS/2, make sure your PS/2
and everything connected to it is switched off.
1. Set the scanner to an unused SCSI ID number between 1 and 6
by turning the switch at the rear of the scanner.
For more information, see 'Changing the SCSI ID number' earlier
in this chapter.
2. Plug the SCSI cable (an IBM or compatible cable) into the SCSI
interface connector at the rear of the scanner.
Use the cable supplied with the Horizon Ultra scanner.
3. If the scanner is at the end of your SCSI chain, place the
terminator on the unconnected part of the scanner.
4. Snap the diamond shaped wire clips into the clip brackets to
secure the connection.
5. Connect the other end of the SCSI cable to the SCSI port at the
rear of your PS/2.
6. Connect the power cable to the scanner.
Make sure that you are using the correct power cable for the
voltage in your area.
7. Switch on the scanner.
The scanner performs a self-test: it produces some sounds and the
indicator lights switch on and off. Then the Busy indicator light
(yellow) switches on, until the self-test is finished. After the self-
test the scanner's Ready indicator light (green) switches on.
Chapter 2 — Installing the scanner 31