Attaching The Bass Boost Remote Control; Example Of Installation On The Floor Mat - Pioneer GM-D8400M Owner's Manual

Installation
Attaching the Bass boost remote
control
Attach with tapping screws (3 mm x 10 mm) at an
easily accessible location such as under the dash-
board.
~
Tapping screw
(3 mm x 10 mm)
Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm x 18 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (118 in.) diameter holes
at the point marked, and install the
amplifier, either on the carpet or
directly to the chassis.
Tapping screw
(4mmx30mm)
/
-Floor mat
or chassis
•
Drill a 2.5 mm (1/8 in.)
diameter hole