Table of Contents
Advertisement
Setting
Off
Power management function is off.
When the lamp has been fully cooled
down, the <ON(G)/STANDBY(R)>
indicator changes to green blinking.
In this condition, the projection lamp
Ready
will be turned on if the input signal
is reconnected or any button on the
control panel or remote control is
pressed.
Shut
When the lamp has been fully cooled
down
down, the power will be turned off.
Timer
J
1 )
Press ▲▼ to select [Timer] and then
press the <ENTER> button.
2 )
Press ▲▼ to set the Timer(1~30 min).
Direct on
1 )
Press ▲▼ to select [Direct on] and
then press the <ENTER> button.
2 )
Press ▲▼ to switch between [On] and
[Off].
When this function is set to [On], the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the Direct On function does not work properly.
Standby mode
This function can set the electric power when the
projector is standing by.
1 )
Press ▲▼ to select [Standby mode]
and then press the <ENTER> button.
2 )
Press ▲▼ to switch between the items
as below.
Eco
Network
Note
When selecting [Network], the cooling fans may be
z
running depending on the temperature inside the
projector even if the projector is turned off.
If Standby mode is set to [Eco], you cannot use network
z
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
56
- ENGLISH
Restricts some functions in
standby mode to reduce power
consumption.
Does not restrict functionality
even in standby mode.
If set to [Network], you can use network functions when
z
the projector is standing by.
If [Standby mode] is set to [Eco], the signal come from
z
MONITOR OUT and VARIABLE AUDIO OUT terminals
are unavailable.
P-timer
This function allows you to change the setting of the
P-timer and execute it.
1 )
Press ▲▼ to select [P-timer].
2 )
Press ► or <ENTER> button to access
the submenu.
Mode
J
1 )
Press ▲▼ button to select one mode
among the items as below.
The P-timer display 000:00
appears on the screen and the
Count up
count up starts (000:00-180:00).
The time set in the Timer setting
Count down
appears on the screen and the
countdown starts.
Timer
J
1 )
Press ▲▼ to select [Timer] and then
press the <ENTER> button.
2 )
Press▲▼ to set the [Timer](1-180 min).
Timer is available in [Count down] only. Factory
z
default value is 10 min.
Execute
J
1 )
Press ▲▼ to select one among the
items as below and then press the
<ENTER> button.
Start
It executes the count up or count
down function.*
Reset
Reset the P-timer values.*
Exit
To exit the P-timer operation.
*1 :
Press the <ENTER> button at [Start] and the
indication changes into [Stop]. To stop Count up
or Count down, press the <ENTER> button at
[Stop] on the screen menu, then the indication
changes into [Restart]. Press the <ENTER>
button at [Restart] to resume Count up or Count
down.
*2 :
Press the <ENTER> button at Reset to return to
the following value:
1
2
Advertisement
Chapters
Table of Contents
