About Your Projector; Remote Control - Panasonic PT-VW431DU Operating Instructions Manual

About Your Projector

Remote control

(17)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(1) <AUTO SETUP> Button
Execute the setting of Auto setup in the setting
menu. ( page 53)
Æ
(2) Input Selection Buttons: <COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>,
<S-VIDEO>, <COMPONENT>,
<DIGITAL LINK>.
These buttons are used to select the input
signal. ( page 33)
Æ
(3) ▲▼◄► Buttons, <ENTER> Button
Navigate the MENU display. (
(4) <SCREEN> Button
Select a screen mode. (
(5) <MENU> Button
Open or close the On-Screen Menu.
( page 37)
Æ
(6) <FREEZE> Button
Pause the projected image and sound
tentatively. ( page 34)
Æ
(7) <AV MUTE> Button
Temporarily turn off the image on the screen.
( page 35)
Æ
(10)
(11)
(12)
(13)
(14)
(15)
(16)
page 37)
Æ
page 33)
Æ
(8) <D.ZOOM +/–> Buttons
Zoom in and out the images. (
(9) <VOLUME +/–> Buttons
Adjust the volume of the speaker. (
(10) < > Button
Turn the projector on or off. (
(11) <KEYSTONE> Button
Correct keystone distortion. (
(12) <INFO.> Button
Operate the information function. (
(13) <LAMP> Button
Select a lamp mode. (
(14) <P-TIMER> Button
Operate the P-timer function. (
(15) <IMAGE> Button
Select the image mode. (
(16) <MUTE> Button
Mute the sound. ( page 36)
Æ
(17) Remote control signal emitter
Attention
Do not drop the remote control.
z
Avoid contact with liquids.
z
Do not attempt to modify or disassemble the remote
z
control.
Note
The remote control can be used within a distance of
z
about 7 m (22.97 ft) if pointed directly at the remote
control signal receiver. The remote control can control at
angles of up to ± 30 ° vertically and ± 30 ° horizontally,
but the effective control range may be reduced.
If there are any obstacles between the remote control
z
and the remote control signal receiver, the remote control
may not operate correctly.
You can operate the projector by reflecting the remote
z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receiver is lit with a
z
fluorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
page 35)
Æ
page 35)
Æ
page 29)
Æ
page 34)
Æ
page 34)
Æ
page 35)
Æ
page 35)
Æ
page 36)
Æ
ENGLISH -
17