Kenwood VR-506 Instruction Manual page 23

0 Use the INPUT SELECTOR to select the video source (other than
"VIDEOl") you want to record
Q Set the video deck connected to VIDEO 1 to record
l
Select the REC MODE to record a digital input source
@ Start playback, then start recording
l
Recording may not be normal for some video software This is due to
the copy guard condition
-gj
rewording audio (digital sumes)
-_ -, ..- - - .I - - I ."
Switch on the REC mode to record a digital input source
Usually use the A-REC (Auto-Record) mode to record audio input
sources When tl)e digital mode changes during recording in the A- REC
mode, the audio input source may be interrupted momentarily To record
the audio input source from the beginning of the digital mode change, use
the M-REC (Manual-Record) mode
Recordiio music in A-REC or M-REC mode
-
INPUT S:LECTOR
0 Use the INPUT SELECTOR to select the source (CD, DVD or
VIDEOP) you want to record
0 Set the cassette deck or MD recorder to record
6 Press and hold the DIMMER key for more than 2 seconds to
select the A-REC or M-REC mode
l
The mode changes every 2 seconds as shown below
i
0 Ret mode off : The digital input record mode is
switched off
@ A-REC : The digital input signals (DTS,
Dolby Digital, or PCM) are identi-
fied automatically and converted
into stereo signals that are ready
for recording
0 M-REC : The input signal type at the mo-
ment this mode Is selected is held
throughout this mode
For A-REC mode:
i i . . . . ,.....
; ii ;
-WITAL
i j ii.! j
STlrlGO
The receiver can store up to 40 stations in the memory and recall them by
one-touch operation
MULTI CONTROL
I
INPUT SELECTOR
BAND AUTO/CINEMA EQ
RC-R0511 RC-R6615/R0617
a ;e$he INPUT SELECTOR knob (TUNER key) to select the
q
Use the SAN0 key to select the desired broadcast band.
Each press switches the band
"AM" or "FM" indicator
as follows:
appears in the display
r
OFM
OAM
a LI$$?~I'$C~NEMA EL? key to select the desired
Each press swliches the tuning method as follows:
r
0 AUTO lit (auto tuning)
"AUTO" indicator lights up
0 AUTO not fit (manual tuning) in the display
l
Normally, set to "AUTO" (auto tuning) If the radio waves are weak
and there is a lot of interference, switch to manual tuning (With
manual tuning, stereo broadcasts will be received in monaural )
q
Use the MULTI CONTROL keys to select the station.
Frequency
display
"ST " lights when a broadcast
is being received in stereo
"TUNED" is displayed when a
station is received
Auto tuning : The next station is tuned automatically
Manual tuning : Turn the knob (press the key) to select the
desired station
0 Start playback, then start recording
l
If the audio reproduction stops in the middle due to change in the
input signals, etc , press the DIMMER key