Kenwood VR-506 Instruction Manual page 22

The MUTE key lets you mute the sound of the speakers
Press the MUTE key
Press the MUTE key again so that the "MUTE" indicator goes off
Rz?cording a music source
l
MUTE ON can also be deactivated by turning the volume control
When recording a music source, switch the VIDE02/MONITOR
knob
setting to "MONITOR"
-La
Use this function to pass the source material direct to the amplifier,
bypassing any audio processing
Press the SOURCE DIRECT key
s DIRECT
-I
l
When you press the LISTEN MODE, SOUND, or SET UP keys, or
switch to another input source, SOURCE DIRECT playback will be
canceled
l
If CINEMA EQ is switched ON, SOURCE DIRECT key will not be
effective
cancel
Press the SOURCE DIRECT key again
l
If SOURCE DIRECT playback was activated while in surround mode,
canceling SOURCE DIRECT playback will reactivate the previous
surround mode
0 (VR-506/KRF-V6050D)
Press the SPEAKERS A or B key so that the speaker indicator
goes off
(VR-505/517/'/5050D/V555OD)
Press the SPEAKER key so that the speaker indicator goes off
Make sure the SPEAKERS
indicators are turned off
-I
Make sure the SP indicators
are turned off
-I
VR-506/KRF-V6050D VR-505/517/KRF-V5050D/
V5550D
l
If you turn off all of the speakers when in surround mode, the
surround mode will becanceled as well, resulting in stereo playback
0 Connect headphones to the PHONES jack
_Remrd@y audio (analup sources) 1 -_ 1_
,. , - j,. ,,-
MONITOR
INPUT SELECTOR
0 UsethelNPUTSELECTOR knobtoselectthesource(otherthan
"TAPE") you want to record
0 Set the cassette deck or MD recorder to record
0 Stat-l playback, then start recording
When recording a music source, switch the VIDEOS/MONITOR
setting to "MONITOR"
-m
MONITOR - MD/TAPE recording
0 Press the MONITOR key
0 Use the INPUT SELECTOR knob to select a source other than
"MD/TAPE"
0 Start playback on the cassettedeckconnected to the MONITOR
jacks and start recording on the cassette deck or MD recorder
connected to the MD/TAPE jacks
MD/TAPE - MONITOR recording
0 Use the INPUT SELECTOR knob to select "MD/TAPE n
0 Start playback on the cassette deck connected to the MD/TAPE
jacks and start recording on the cassette dec! or MD recorder
connected to the VIDE02/MONITOR jacks
l
To copy tapes using a double cassette deck, refer to the instruction
manual of the double cassette deck
MONITOR function (analo# sources only)
You can connect a cassette deck or graphic equalizer to the VIDEOS/
MONITOR jacks of the receiver If a graphic equalizer is connected, the
MONITOR key should be left in the on position Alternately, if a cassette
deck equipped with a S-head system is connected to the VIDE02/
MONITOR jacks, you will be able to monitor the just-recorded signal
while making recordings on the cassette deck By switching the MONI-
TOR key on and off, you can compare the sound of the source signal
and the just-recorded signal For more information, refer to the instruc-
tion manual of the connected component
0 Use the VOLUME CONTROL knob (VOLUME keys) to adjust the
volume